Search results

Hey there everyone. This morning while doing a fairly large brisket my battery pack for my HM died. I woke up plugged it into the wall and off it goes. I was fully expecting the data to be gone (my previous experience) but much to my surprise HM kept my data and I have it all. It picked...

That would explain my error. Thanks for that....I did indeed grab the wrong files! Guess I'll experiment with this one and have the reprint run. Appreciate it.

I just printed my first offset rotary blower and I had a question. The print job came out with a round hole where the 1X2 square tubing is destined to go. Should I use a round piece of tubing here and this is an updated version of the original solution or should I take a dremel to this and...

It is terrifying how well you know the product. Resoldered the shift register and off she goes. Took care of the rest of the solders on this side again as well after I tested the ic. Thank you very much.

Hey everyone, I'm new around and I've got an HM 4.3 that I've built married up to a pi3 and I've got some odd issues that I wanted to see if I could get some advice on. The LCD is outputting strange characters when I power it up. Then after a bit it usually will give me the IP address, then...