Recent content by Pavlov_Jones

Thank you guys for all your advice. When I get back from work, I'll try all of these and provide more information.

Ok. I tried a different K type Thermocouple from Auberin. It reads around 40 degrees celsius when it is 20 degrees celsius actual... I'll update when I know more. I did the hot hand on thermocouple test, and it adjusted for that, so it works, but the probe is double the real temp... hmmm...

Oh man. Now it is hovering around 128f at room temp so it should be 60f. I'll have to think about what is going on ...

I reset to: Probe: 0 = Thermocouple 5mvc Probe: 1,2,3 = Internal, Vishay 10k Then turned off. Washed it in isopropyl alcohol, then turned it on again. The temperature is now reporting a much more sensible, and much more realistic 67 degrees F ... slightly falling, rising, falling ... but very...

Hi Bryan, Ok. I have Set Probe 0 to Thermocouple, mVC 5, and Probe 1,2,3 to Internal (Thermistor) Vishay 10k. Then I saved, and power cycled. Upon reset the LCD no longer shows -No Pit Probe-, it displayed the ip address as normal, then shows Pit:43 Degrees. And it has been rising about 1...

Hi all! Finally built my Heatermeter v 4.2.4 Thermocouple version, and the whole build went smoothly. I have mated it with a Raspberry Pi successfully. I have successfully set it up and accessed it via the network. This looks to be a brilliant device so far. I have read the setup information...

Hi Wbeg, Wondering how I can get one of these amazing barrel servo dampeners :-) Anyone in Australia with a 3D Printer?

Hi Ralph, Wondering if you are able to sell this already assembled or in a kit? I am a bit intimidated by the aux board you have created, would it be possible for a layman to assemble one of these?

Hi Everyone! I'm very keen to get a Heatermeter but I am not sure if it is practical to order the parts to put it together as I am in Sydney, Australia and the cost of shipping from USA to here seems quite prohibitive. Just wondering if there are any Aussies who have built this? If so, could I...

Can anyone build a 4.2 one for me? I am in Sydney, Australia but would pay shipping in addition to reasonable cost of someone spending their time to assemble...